AS G19-1966 PDF Download
$33.00Specification for wrought alloy steels of the AISI-SAE standard steels type
standard by Standards Australia, 01/01/1966
Standards Australia
Standards Australia is an independent, not-for-profit organization recognized by the Australian Government as the peak non-government Standards body in Australia. The organization develops internationally aligned Australian Standards that enhance the nation’s economic efficiency, international competitiveness and contribution to community demand for a safe and sustainable environment. Standards Australia is the Australian member of ISO and IEC.
Specification for wrought alloy steels of the AISI-SAE standard steels type
standard by Standards Australia, 01/01/1966
Schedule of steel sheet for automobiles and deep drawings
standard by Standards Australia, 01/01/1945
Specification for wrought alloy steels of the AISI-SAE H steel type
standard by Standards Australia, 01/01/1966
End-quench test (Jominy test) for hardenability of steel
standard by Standards Australia, 01/01/1969
Steel castings for general engineering puposes
standard by Standards Australia, 01/01/1969
Cold rolled low carbon steel strip to temper designations (coils and cutlengths)
standard by Standards Australia, 01/01/1968
Hot-dipped galvanized (zinc-coated) flat steel sheet (coils and cutlengths)
standard by Standards Australia, 01/01/1967
3-in pitch corrugated hot-dipped galvanized (zinc-coated) steel sheets
standard by Standards Australia, 01/01/1969
Hardened and tempered carbon steel bars for general engineering purposes
standard by Standards Australia, 01/01/1968
Hot-rolled carbon and carbon-manganese steel plate for general engineering purposes based on chemical composition
standard by Standards Australia, 01/01/1968
Terne-coated steel sheet (cut lengths)
standard by Standards Australia, 01/01/1969
Hot-rolled spring steels
standard by Standards Australia, 01/01/1971
Specification for carbon steel bars for the manufacture of hot-forged rivets
standard by Standards Australia, 01/01/1961
Carbon and carbon-manganese steel forgings for general engineering purposes (ruling section up to and including 12 in)
standard by Standards Australia, 01/01/1970
Stainless and heat-resisting steel plate, sheet and strip of the AISI-SAE standard steels type (coils and cut lengths)
standard by Standards Australia, 01/01/1971
Circular and non-circular carbon steel tubes for mechanical and general engineering purposes
standard by Standards Australia, 01/01/1971
Hot-rolled carbon steel strip to strength and forming requirements
standard by Standards Australia, 01/01/1971
Specification for carbon steel wire for the manufacture of cold-forged rivets
standard by Standards Australia, 01/01/1961
Specification for hot-forged steel rivets (not exceeding 2 inches in diameter)
standard by Standards Australia, 01/01/1961
Specification for cold-forged steel rivets (not exceeding 1/2 inch in diameter)
standard by Standards Australia, 01/01/1961